If you're a homeowner and have had to call a plumber to fix a problem, you know how expensive and annoying it can be. Wouldn't it be great if you could fix your plumbing yourself? Well, it might be easier than you think! Read on to find out how.
Make sure everyone that lives in your house knows where to find and use the main water shut off valve in case there is a burst pipe emergency. This is especially important if you live in an area where your pipes may freeze. Take a moment to show your family members where the valve is and how to properly shut it off.
When starting a plumbing project that is due to loud noises in your pipes empty the pipes first. This can be an easy fix to an other wise wasted huge job. Just close the main water line and open the facets throughout the house. After the water has stopped flowing turn the water on from the main source and check to see if the noise is eliminated.
To maintain a clean, well-functioning septic tank, it is recommended that you clean it out once every five years. Septic systems can back up when the septic tank builds up sediment. This can even result in the septic system failing altogether. It is a small price to pay now to keep your septic in good working order and prevent having to pay for a major repair caused by a backup.
To winterize a house that will sit unused during the winter months, you must completely drain all of the pipes. After turning off the main water supply, let all of the water drain from the faucets, toilets, and water heater (turn off the gas). Add a quart of antifreeze to sinks and the tub to prevent water from freezing in the drain trap.
It is not always necessary to call in a plumber when you have a damaged section of pipe in your plumbing. There are repair kits you can buy in your local hardware store which are excellent in repairing leaks. If you have a small leak, you can rub a compound stick over the hole or crack in the pipe to seal it shut. Epoxy paste is also an excellent remedy for a leaking pipes. Make sure you turn off the water and completely dry the pipe before applying the epoxy.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
Basic problems with toilets can be a quick fix for even the rawest amateur plumber and is worth attempting if you can take the time to research the problem. Seek out the necessary part or parts from your local hardware store and ask for support in how to properly install them.
Sometimes you have to make the choice between replacing or repairing. If you have an old appliance, that uses a lot of water or electricity, it may be best to replace. Sure, it will cost more initially, but it will save you money in the long run. The other thing is, you can't be sure how well a repair will work out, whereas with a new appliance you'll at least get a guarantee.
Your water heater works more during the fall and winter so make sure that you eliminate all sediment buildup around this piece of equipment. Flushing this device can lead to increased longevity so that you do not face plumbing problems during the winter. This precaution will save time, money and effort.
As you can see, solving your plumbing problems yourself can be a satisfying way to save money and take care of your house independently. Next time you have a plumbing problem, you'll be ready to tackle the issue yourself with the tips you've taken from this article.